Home » Computer Science » Computer Hardware
51. 

After doing a low-level format, what would be the next step in configuring the hard drive in a system?
A. Format DOS partition
B. Install operating system
C. Configure DMA channel and back-up interrupt
D. Partition hard disk
E. None of the above
52. 

After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?
A. MEM /P
B. MEMMAKER
C. MEM /C (A SYS:
D. None of the above
53. 

In laser printing, there are six steps the printer follows. What comes between the conditioning phase and the developing phase?
A. transfer phase
B. writing phase
C. fusing phase
D. cleaning phase
E. All of the above
54. 

During the laser printer's conditioning phase a uniform charge of _____ is placed on the photosensitive drum.
A. +1000 volt
B. +600 volts
C. -600 volts
D. -1000 volts
E. + 12 volts
55. 

A dialog box with a bomb appears oh a Macintosh screen. What type of problem has occurred?
A. A RAM problem
B. A software problem
C. A ROM problem
D. An ADB problem
E. None of the above