Home » Computer Science » Computer Hardware
26. 

After doing a low-level format, what would be the next step in configuring the hard drive in a system?
A. Format DOS partition
B. Install operating system
C. Configure DMA channel and back-up interrupt
D. Partition had disk
E. None of the above
27. 

Resistance is measured in ?
A. Volts
B. Amps
C. Watts
D. Ohms
E. None of the above
28. 

What command is used to reset a MODEM when using the "AT Command Set"?
A. ATR
B. ATZ
C. DTR
D. DCE
E. None of the above
29. 

When installing a SCSI CD-ROM drive, you must set the CD-ROM SCSI adapter to:
A. B0007
B. An unused SCSI address
C. The same address as the SCSI device before the CD-ROM
D. SCSI ID=1
E. None of the above
30. 

Pick the correct choice for the 80386SXCPU.
A. 16 bit word size, 16 bit data path
B. 32 bit word size, 16 bit data path
C. 8 bit word size, 32 bit data path
D. 32 bit word size, 8 bit data path
E. 32 bit word size, 32 bit data path